• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 KIA Stinger Forum and KIA Stinger community dedicated to KIA Stinger owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the KIA Stinger Forum today!


MBRP Catback install *question*

Messages
43
Reactions
16
#1
Hey everyone, lucked out and my back-ordered MBRP exhaust showed up today. I’m very “mechanically inclined” but was looking for advice on the install. I don’t have access to a lift but have jack stands/can lift the back end of the car in the garage no problem. From the homework I’ve done it looks pretty simple - remove the little brace and then a handful of bolts/studs.

Has anyone done this at home? Trying to gauge if it’s worth it or just pay someone to swap it but knowing how simple it is and knowing I have a toolbox full of tools collecting dust I’d much rather do it myself.

Any insight and/or tips and tricks are appreciated. Can’t wait to hear it with the new exhaust!

Thanks
 

spider55

1000 Posts Achieved
Staff Member
Messages
1,785
Reactions
612
City
Coolidge
State
AZ
Country
United States
What I Drive
2019 stinger GT1
#2
It's a lot easier with a lift, some of the bolts are a pain in the ass to get to. Just make sure you tighten from the front to the rear.

It's easier with two people....(y)
 
OP
D
Messages
43
Reactions
16
Thread Starter #3
Thanks. I figured the two people part may be the bigger issue vs the lift...I’ll make some calls. Thanks for the reply
 

Similar threads



Top